Results 1 to 1 of 1

Thread: 200 Gal acrylic build

  1. #1
    DIYFK member Stryker21's Avatar


    Join Date
    Jun 2017
    Location
    Ontario
    Posts
    5
    Post Thanks / Like

    200 Gal acrylic build

    So I am in the process of building my 6x2 acrylic tank. I've done 3 sides so far and I noticed after I put the Weldon 4 in the seams, there were a few spots that didn't bond right. This has been a few days of curing. And there seems to be some bubbles along the edge.

    i used the pin method and clamped down all along the seams

    Do you think this will be ok?

    my acrylic thickness is 3/4 and there will be braces "euro" with a couple centre braces.

    any advice would be greatly appreciated
    Attached Thumbnails Attached Thumbnails IMG_0087.JPG  

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •